Bestauto Crank Case Splitter Separator and Crank Puller Installer Tool Dirt Bike

February 19, 2020 - Comment
Add to Cart $91.96Amazon.com Price
(as of 20:29 GMT+0100 - Details)

Product Description

This item includes both 8mm and 6mm mounting bolts, and makes crankcase disassembly easy by safely pushing the crank assembly out of the case halves 7.7lb. It has adjustable arms permit it to be used on a variety of bolt patterns. The disassembling vertically split 2 and 4-stroke crankcases.

Tusk Crankcase Splitter/Separator Tool

A must for disassembling vertically split 2 and 4-stroke crankcases.

Makes crankcase disassembly easy by safely pushing the crank assembly out of the case halves.

Adjustable arms permit it to be used on a variety of bolt patterns.

Includes both 8mm and 6mm mounting bolts.

-Tusk Crank Puller/Installer Tool

A must for assembling vertically split crankcases.

Safely and easily pulls crank assembly into crankcase.

Heavy-duty steel construction.

Includes both male and female M10x1.25mm and M12x1.25mm adaptors to attach to crank assembly.

The C-clip adaptor is required for cranks that use a C-clip to hold the primary gear on (common on many Kawasaki models).

Notice:

Will not work on: Yamaha Raptor 660, Kawasaki Tecate 250, KTM 125/144/150

Feature

Safely and easily pulls crank assembly into crankcase

Heavy-duty steel construction

Adjustable arms permit it to be used on a variety of bolt patterns

Specifications

Weight: 7.7lb (3.5kg)

Dimensions (Lx Wx H): 11″x8.6″x5.9″ (28x22x15cm)

Package Content

1 x Crank case splitter separator and crank puller installer tool dirt bike

Product Features

  • ★SAFELY AND EASILY- Pulls crank assembly into crankcase
  • ★HEAVY-DUTY- steel construction
  • ★INCLUDES BOLTS-Includes both 8mm and 6mm mounting bolts
  • ★ADJUSTABLE ARMS PERMIT-It to be used on a variety of bolt patterns
  • ★MAKES CRANKCASE DISASSEMBLY EASY- By safely pushing the crank assembly out of the case halves

Comments

Anonymous says:

Rear Axle Shaft Bearing Hub Puller for Toyota Trucks Nice tool for the job. Very well built. The only issue I had was that neither flanged end would fit in my Harbor Freight 20-ton press. I had to cut one end off to be able to finish my job. No one claimed that it would fit in the 20-t press, so that’s on me. Other than that, it worked fine and I can weld a piece of tubing to the flange I cut off if it’s needed for a different vehicle.

Anonymous says:

Works with a 20 ton press if you modify the flange The tool works well and did press the retainer and bearings off the axel after I cut both sides of the round flange to fit between the support on my 20 ton press. As a side note the 20 ton HF press is a tight fit to remove the Tundra axel bearings when using this tool. I had to loosen the four bolts allowing the axel to drop 1/16 of an inch to get the tool and axel under the ram. Once the axel and tool are under the ram I Tightened up the four backing plate bolts then proceeded to press off…

Anonymous says:

best auto easy to work with the case splitter was perfect. the crank puller was missing a part of the tool which you can not buy separatly. they adjusted the price so i could have the part made and now i have a tool that works perfectly. these tools are for splitting motorcycle crankcases and pulling them back together. I recommend bestauto and will purchase from them again

Write a comment

*