Mytee Products Trailer Stake Pocket D-Ring Flatbed Utility (8 – Pack)

August 16, 2019 - Comment
Add to Cart $119.99Amazon.com Price
(as of 04:30 GMT+0100 - Details)

Fits 3.75″ ID Stake Pockets (Standard 2 x 4 Stake Pockets) Anchor Dimentions: 5.5″ Tall from bottom of the mounting plate to the bottom of the anchor 3.5″ Wide 4.40″ From bottom of the mounting plate to the top of the 2nd pin hole 3.25″ From bottom of the mounting plate to the top of the 1st pin hole

5/8″ diameter Forged D-Ring Inside Dimentions of D-Ring 3″ x 2.5″ Provides convenient D-Ring tie down where needed Fits common flush and outside stake pockets Black Powder coat finish 1/2″ hitch pin w/ cotter Working load limit is 5,400 lbs Capacity: 16,200 lbs

Product Features

  • Stake Pocket D-Ring
  • 5/8″ Forged D-Ring
  • Fits 3.75″ ID Stake Pockets (Standard 2 x 4 Stake Pockets)
  • Working load limit is 5,400 lbs
  • Capacity: 16,200 lbs

Comments

Anonymous says:

Fits perfectly but… This item fits the pocket perfectly. It is very heavy duty. The d-ring is what I’ve been looking for.The problem I have is with the hitch pin. The hole for the cotter pin needs to be drilled about an eighth of an inch further out. Presently it’s to snug against the side of the pocket. The lip of the pocket interferes with the cotter pin going in but I was able to get three of the four in place. The 4th I’m going to have to bend the hitch pin just a little bit to get it to slide far…

Anonymous says:

An honest review I think these are great. They work as they should. The only issue I had was the pins dont fit all the way through the other side of the C channel so you can get the cotter pin through the hole. Had to bend the C channel in with a mini sledge hammer to make it work. The items weren’t packaged very good. The 8 stake pocket D rings are all chipped and scratched up pretty bad. I still give this item 4 stars due to the usefulness of this product and these will get scratched eventually. With minor…

Anonymous says:

Fits My Trailer Stake Pockets Perfectly! I have a 2018 Carry-On flat-bed car hauler trailer. These D-rings fit the pockets perfectly.The Mytee Products D-rings are very heavy duty. These have a WLL of 5400 lbs and are marked as such. The D-ring is much bigger and heavier than I expected. The workmanship is very good on these and the welds look great.They include the pins/cotter pins to secure these to a trailer stake pocket but I’m going to weld them in place because I can’t ever envision needing to remove…

Write a comment

*